1. Begin by starting the installation with the suspension system still connected to the ATV. Place the chassis or frame of the ATV on a firm level surface.

2. Secure any loose wires and other components of the suspension system.

3. Working from the inside of the ATV, loosen the nut that is located at the top of the ball joint. Place a socket and ratchet on the nut to loosen it.

4. Count the number of turns it takes to loosen the nut. This help facilitate its reinstallation later on.

5. Take special care and use a hammer to drive out the ball joint from the suspension’s control arm. Use caution to ensure that the control arm does not bend as the ball joint is driven out.

6. Insert the new ball joint into the holes located in the control arm and the frame of the ATV.

7. Once the new ball joint is in position, tighten the nut using the same number of turns it took to loosen it.

8. Finally, adjust the ball joint’s toe setting as necessary to ensure proper alignment of the suspension system.

“Keyword”
“atv ball joint tool”
“honda atv ball joint tool”
“tusk atv ball joint tool”
“atv ball joint separator”
“polaris ball joint install tool”
“yamaha atv ball joint tool”
“how to tell if atv ball joints are bad”
“how to install super atv ball joints”